Hi All, I had downloaded the 1.8.2 iso, and had upgraded a 1.8.0 cluster successfully. I just blew that cluster away and started again. With that iso though on a fresh install it only installs 1.8.0, and then i have to run the upgrade with the same iso to get it to 1.8.2 . Is that normal? We are just starting with Harvester, so in learning mode.

by chance are you booting/installed from PXE? DId you update the yaml to point to the new iso version? I have done this once… 😄

hah not in this case , i am having to attach as a virtual cd via idrac, and i just keep it attached and then upgrade afterwards...so :/

ah. you should look into pxe. 😄

shall do...

Love your vids, watch them a lot will take a look. I've been wrangling with harvester all day, do you run it for container loads as well as vms?

just vms. I have 2 single nodes clusters here. 1 is my infra, truenas and a vm to boot PXE. then the other is the homelab playground.

nice... trying to move off vmware, mix of containers and vms, networking stuff does my head in

right now running pods/containers in vms is an easy to keep things logicaly separated. and for me truenas has the 3 apps I use for infra, plex, adguard, and tailscale.

yeah ... that's what we currently do in prod, I was just really keen to get native as close to the baremetal etc... sure will get it eventually....

Suse still doesn’t fully recommend it. do you pull done the kubeconfig from harvester to them run helm?

yeah its going GA 1.9, so i thought id start getting ready for it and try it out

oh cool. didn’t hear about 1.9 yet.. flux makes things easy.

yeah i like its simplicity